Overview

The NefMoto ME7 ECU flasher is a free tool that allows you to read and write the flash memory in your ME7 ECU in car over the OBD port. All that is required is a FTDI based USB OBD cable that works in "dumb" mode. Dumb mode cables pass the raw serial data straight through without applying any higher level protocols.

Features

• ECUs can be written through the OBD port in about three and half minutes.
• ECUs can be read through the OBD port in about five minutes.
• User defined memory layouts allow for flashing any memory arrangement.
• Writing erases and programs one memory sector at a time to allow you to recover the ECU in case of failure.
• Written and read data is verified with checksums to ensure data was sent correctly.
• Reading and clearing error codes is also supported.

What this software does not do

• Does not update checksums or validate the file you are flashing in any way.
• Does not allow you to edit any maps, value, etc. It is just for flashing.

System requirements

• 32bit or 64bit Windows Vista or Newer (Will work if run inside a virtual Windows machine on Mac and Linux as well)
• .NET 3.5 (installed automatically with Nefmoto ECU flashing software)
• FTDI USB D2XX driver version 2.06.00 or later
• 3 megabytes of free hard drive space

Known issues

• No known issues. Please let Tony know if you find any.

Installation

Download

The Nefmoto ECU flashing software is free to download and use. The latest release can be found here: NefMoto ME7 Flasher Logger 1.9.0.0

How to install

• Please uninstall any previous versions of the NefMoto ME7 ECU Flasher before installing the latest version.
• Run NefMoto ME7 Flasher Logger 1.9.0.0.msi.
• Ensure that you have the FTD2XX driver installed for your specific cable.
• If you have a generic cable, download CDM20600.zip (link above), then extract it and install the generic FTDI D2XX driver.

Use

This section needs some love, please contribute!

• Connect your vehicle's battery to a constant, stable power source. This is vital, if the ECU loses power or voltage dips during any flashing operation recovery may require flashing through ECU Boot Mode or worse.
• Connect your flashing cable to your vehicle's OBD port.
• Turn on your ignition (but do not start the car). If the cable has an LED light it should illuminate.
• Select the memory layout for your ECU.
• At the top of the program choose Fast or Slow Init and Connect
• Choose one of the program options (Read/Write/etc)
• You will notice the activity in the console window
• When your operation is complete, choose Disconnect at the top of the program.

Supported cables

Tested supported cables

• eBay USB VAG KKL using the FTDI D2XX standard driver (Non-affiliated eBay stores: 1 2)
• Ross-Tech HEX-USB-CAN using the Ross-Tech FTDI D2XX driver ("boot in intelligent mode" must be unchecked in the VCDS options screen)
• Any dumb OBDII cable using the FTDI USB chip

Tested unsupported cables

• Galletto (Does not support dumb mode)
• KWP2000+ Flasher (Does not support dumb mode)
• Old Ross-Tech KEY-USB (Does not support true dumb mode)

If you want to check what chip is in your cable, or see if it supports NefMoto premium features, you can use the NefMoto ECU Flasher version 1.6.1.0 or later. Just select the USB device and then hover your mouse over it. It will display all of the info about the FTDI chip in the cable and say if it supports premium NefMoto features.

Tested ECUs

List of ECUs that the NefMoto ECU flashing software has been tested and is supported on: